JVC 0709TMH-II-IM User Manual

420) Cautions for installation— Do not tilt the TV towards the left or right, or towards the back.— Install the TV in a corner on the floor so as to keep cords out of the way.— The TV will generate a slight amount of heat during operation. Ensure thatsufficient space is available around the TV to allow satisfactory cooling.— Have two people remove the TV from the box with the screen facing awayfrom you. It's possible your clothing, (such as a belt buckle or button) mayscratch the front of the TV. Do the same when moving the TV to anotherlocation.21) When attaching to a wall, use the optional JVC wall mounting unit.For LT-32J300 / LT-32JM30: JVC-XUF-2637 LCD FLAT WALL MOUNTFor LT-42J300: JVC-XUF-2637 LCD FLAT WALL MOUNTFor LT-46J300: JVCPCM-MS2 TILT/FLAT WALL MOUNTCaution— Consult qualified installers.— See the included manual on mounting procedures.— JVC is not responsible for damages or injuries due to improper mounting.— Use with other wall mounting unit is capable of resulting in instability or causing possibleinjury.22) Make enough room for inserting and removing the power plug. Place the TV as closeto the outlet as possible. The main power supply for this TV is controlled by inserting orremoving the power plug.23) Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.24) When this TV is connected to the wall outlet, it is always on standby even when all the LEDlamps are not lit. To shut down the TV, unplug the TV from the wall outlet.Important Safety InstructionsFCC Notice:Caution: Changes or modifications not expressly approved by party responsible forcompliance could void the user's authority to operate the equipment.Note: This equipment has been tested and found to comply with the limits for a Class Bdigital device, pursuant to Part 15 of the FCC Rules. These limits are designed to providereasonable protection against harmful interference in a residential installation. Thisequipment generates, uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in aparticular installation. If this equipment does cause harmful interference to radio or televisionreception, which can be determined by turning the equipment off and on, the user isencouraged to try to correct the interference by one or more of the following measures:– Reorient or relocate the receiving antenna.– Increase the separation between the equipment and receiver.– Connect the equipment into an outlet on a circuit different from that to which the receiver isconnected.– Consult the dealer or an experienced radio/TV technician for help.