JVC 0200JTMMDWJSCEN Instructions Manual

9English• If you try to program a 33rd step“MEMORY FULL” will appear in the displaywindow, and your entry is ignored.• The total playback time of programed tracksexceeds 99’59”“– – : – –” will appear in the display window.6 Press 6 (play/pause) button on the MD recorder.The programed tracks are played back in the order youhave set.7 Press 7 (stop) button to quit Program play.• When Program play finished, MD recorder auto-matically stops.To check the program contentsBefore playing back the MD, you can check the programcontents by using 4 / ¢ button.Press ¢ button:Shows the programed tracks in the programedorder.Press 4 button:Shows them in the reverse order.To modify the programBefore playing back the MD, you can erase the lastprogramed track by pressing CANCEL button. Each timeyou press the button, the last programed track is erased fromthe end of program.• To add new tracks to the program before you startplaying-back, simply select a track number again youwant to add (repeat steps 3 to 4).To erase all the programed dataAfter playing back the MD, you can erase all the programedtrack data by pressing 7 (stop) button. New program canbe entered again.To exit from Program play modeBefore or during playback, you can exit from Program playmode as follows:• Before playback, press PLAY MODE button twice.• During playback, press 7 (stop) button then PLAY MODEbutton twice.Playback mode indicator goes off and the system resumesNormal play mode.Pressing 00000 (eject) button to eject the MD also quitsProgram play mode.ContinuedPROGRAMCanceled(Normal play)RANDOMPrograming the Playing Order of the Tracks— Program PlayYou can arrange the order in which the tracks play beforeyou start playing. You can program up to 32 tracks.1 Insert an MD.• If the current playing source is not the MD, press6 (play/pause) button on the MD recorder, then7 (stop) button before going to the next step.2 Press PLAY MODE button repeatedly until “MDPROGRAM” appears in the display window.• Each time you press the button, playback modeindicators also change as follows:3 Rotate MULTI JOG dial to select a track number tobe programed (< / > button also available).Track numberProgram number4 Press SET button to enter selected track number tobe program-played.Track numberProgram numberHere the track number 2 of the MD is stored into aprogram number 1, and shortly after that the totalplayback time of programed tracks appears in the displaywindow as follows:Total playback time5 Repeat steps 3 to 4 to program other tracks youwant up to 32 tracks.