SP-5000M-USB / SP-5000C-USB- 12 -Table 5. Hirose 12P pin assignmentNote1: Factory default is Exposure Active, NegativeExposure Active is positive polarity inside camera operation but it is converted toNegative by using the signal polarity function of TTL OUT 1 and output.Note2: Factory default is Trigger In5.2.3 AUX Standard Hirose 10-Pin connector5.2.3.1 Figure and pin configurationType : HIROSE 10-Pin Connector 3260-10S3(55)Fig.5 Hirose 10-pin connectorTable 6. Hirose 10P pin assignment (Standard)No I/O Name Note1 O DRIVE IRIS+ Motorized Lens2 O DRIVE FOCUS+ Motorized Lens3 O DRIVE ZOOM+ Motorized Lens4 O COMMON Motorized Lens5 GND6 O P-IRIS OUT A+ P-Iris Lens7 O P-IRIS OUT A- P-Iris Lens8 O P-IRIS OUT B+ P-Iris Lens9 O P-IRIS OUT B- P-Iris Lens10 O GNDPinno.I/O Signal Remarks1 GND2 I DC in +12V ～ +24V3 GND4 NC5 I Opto in1- Line56 I Opto in1+7 O Opto out1- Line28 O Opto out1+9 O TTL out1 Line1 (Note1)10 I TTL In1 Line4 (Note2)11 I DC in +12V ～ +24V12 GND18
