IHP Ravenna RDV33 Installation And Operation Manual

IHP Ravenna RDV33 Installation And Operation Manual Manual pdf 26 page image

26Electrical Requirements:This gas appliance operates without an outside power source, howeverthe blower requires a 120 Volt electrical service outlet. This appliance,when installed, must be electrically grounded in accordance with localcodes, or in the absence of local codes, the National Electrical Code ANSI/NFPA 70 - latest edition. (See Operating Options for thermostat and ON/OFF switch information).CAUTION: Label all wires prior to disconnection when servic-ing controls. Wiring errors can cause improper and dangerousoperation.ATTENTION: Au moment de l'entretien des commandes,étiquetez tous les fils avant de les débrancher. Des erreursde cáblage peuvent entraîner un fonctionnement inadéquatet dangereux.Fuel ConversionConverting this appliance between natural gas and LP can be accomplishedby installing a conversion kit (valve regulator and burner orifice). Only aqualified service technician should perform the conversion.Conversion Kit: Please see instructions provided with conver-sion kit.Blower RemovalUnplug the power supply cord from the electrical outlet prior to removingthe blower. The blower can be accessed through the back wall of the firebox.Remove the insert face, glass door, log set and firebox liner panels. All ofthese items are fragile so handle them with care. Next, remove the nineallen head screws around the outside of the panel fastened to the backwall of the firebox. Rotate the top of this panel toward the front, removethe two wires connected to the blower and then lift the panel with theblower attached out of the firebox. To reinstall the blower, repeat thesesteps in the reverse order.Blower Wiring SchematicFigure 21Green (Ground)Black (Hot)From Power SourceSpeed ControlWhite (Neutral)BlackBlowerWhiteBlower Snap Switch