IHP BarcelonaLights36ZEN Installation And Operation Instructions Manual

Contents

IHP BarcelonaLights36ZEN Installation And Operation Instructions Manual Manual pdf 28 page image

IHP.us.com 900861-00NC28LIGHTING INSTRUCTIONSREAD ALL WARNING AND SAFETY INFORMATION ABOVE BE-FORE ATTEMPTING TO LIGHT FIREPLACE1. Turn ON main gas supply and check all fittings and connectionsfor leaks with a soap and water solution.HOW TO TURN ON2. Push the “I” on the ON/OFF switch to turn ON (System will takeapproximately 7-10 seconds before ignition after the gas lineFigure 40 - Control panelWARNING: Do not use this appliance if any part has been underwater. Immediately call a qualified service technician to inspectthe appliance and to replace any part of control system and anygas control, that has been under water.CAUTION: Children and adults should be alerted to the hazardson high surface temperatures and should stay away to avoidburns or clothing ignition. Young children should be carefully su-pervised when they are in the area of the appliance.SAFETY WARNINGS1. Never leave the fireplace unattended during operation.2. Clothing or other flammable materials should not be hungfrom the appliance or placed on or near the appliance.3. Any guard or other protective device removed for servicingthe appliance must be replaced prior to operating the appli-ance.4. Installation and repair should be done by a qualified serviceperson. The appliance should be inspected before use and atleast annually by a qualified service person. More frequentcleaning may be required as necessary. It is imperative thecontrol compartment, burners and circulating air passage-ways of the appliance be kept clean.5. Inspect the fuel supply connection before each use of the ap-pliance.6. Temporary storage of this appliance indoors is permissibleonly if it has been disconnected from its fuel supply (Naturalor L.P. gas line).WARNING1. This appliance is hot when operated and can cause severeburns if contacted.2. Do not burn any solid fuels in this appliance.3. These appliances are not designed or intended to be used forcooking. Do not barbecue, heat food, or roast marshmallowsin this appliance. Doing so could damage the appliance andcause injury.4. These appliances are not designed or intended to be used forcooking. Do not barbecue, heat food, or roast marshmallowsin this appliance. Doing so could damage the appliance andcause injury.is purged). During this time, an “Ignition In-Process” beepingpattern will take place. (e.g. one short beep, pause, three shortbeeps, pause; repeated until ignition occurs). NOTE: Beepingpattern may be difficult to hear outdoors.3. The main flame ignites (defaults) in the HIGH position. Pressthe “I” on the LOW/HIGH button to adjust to the LOW setting.4. A continuous pilot flame can be turned ON or OFF with the con-tinuous pilot button.5. Push the “I” on the LED ON/OFF switch. LED’s will turn ON. Ad-just the intensity of the lighting by turning the knobs clockwiseon each dimmer knob. There is infinite color combina-tions by adjusting the dimmer knobs to personal taste.HOW TO TURN OFF1. To turn OFF the fireplace press the “O” position on the ON/OFFswitch. This will turn OFF the fireplace. NOTE: Fireplace mustbe OFF for 5-minutes before relighting.To turn OFF the LED lights in the fireplace press the “O” positionon the LED ON/OFF switch. This will turn OFF the LED lights.The LED lights are independent of the fireplace and can be usedwhen the fireplace is not in operation.OPERATIONRGB DIMMERMounting plate under switch coverLEDON/OFFON/OFF LOWHIGH LEARNCONT.PILOT5-5/8”(143mm)5-5/8”(143mm