IEI Technology PM-BT series User Manual

Also see for PM-BT series: Quick installation guide

Contents

IEI Technology PM-BT series User Manual Manual pdf 58 page image

PM-BT SBCPage 464.5.1 LVDS Voltage SelectionWARNING:Incorrect voltages can destroy the LCD panel. Make sure to select avoltage that matches the voltage required by the LCD panel.Jumper Label: J_VLVDS1Jumper Type: 6-pin header, p=2.00 mmJumper Settings: See Table 4-3Jumper Location: See Figure 4-7The LCD voltage selection jumper sets the voltage of the power supplied of the LCDpanel.Setting DescriptionShort 1-3 Backlight Enable +3.3 VShort 2-4 Set the voltage level of panel to +3.3 VShort 3-5 Backlight Enable +5 VShort 4-6 Set the voltage level of panel to +5 VTable 4-3: LVDS Voltage Selection Jumper SettingsFigure 4-7: LVDS Voltage Selection Jumper Locations