ICS 701A Operator's Manual

Also see for 701A: Operator's manual

Contents

ICS 701A Operator's Manual Manual pdf 4 page image

© 2015 ICS, Blount International Inc. Specifications are subject to change without notice. REV041315 F/N 573498701A SERIES OPERATOR’S MANUAL4THE FOLLOWING WARNING SYMBOL APPLIES TO ALL THE ITEMS LISTEDON THIS PAGENote: Chain breakage can result in high-speed ejection of parts, whichcan result in death or serious personal injury to operators or bystanders.The items listed immediately below are critical to minimizing the risk ofchain breakage and injury.• DO NOT operate the machine with damaged, modified or missingcomponents shown below.• Side cover• Mud flap• Rear hand guard• Mud flap bracket (chain catcher)• Trigger interlock• DO NOT exceed 90 psi (6 bar) and 124 cfm (3.5 m3/min) operatingpressure and volume.• DO NOT insert the diamond chain saw into a slot narrower than the chainsegments.Rapid pushback might occur.NOTE: Most ICS diamond chain segments are .225 inches (5.72 mm) wide.• NEVER run a diamond chain saw upside-down.Concrete debris can fly back into the operator’s face.• NEVER cut ductile iron pipe with concrete chain.Segment loss or chain breakage may occur.• NEVER operate the ICS saw with a saw chain or saw bar designed to cutwood.Using wood cutting saw chain on the ICS saw could result in severeinjuries to operator and bystanders! Use ONLY the cutting attachmentsspecified in this manual on this machine.SAFETYWARNING Indicates a hazard with a medium level of riskwhich, if not avoided, could result in death orserious injury.