ICP DAS USA UA-5200 Series User Manual

Also see for UA-5200 Series: Quick start User manual Quick start

Contents

ICP DAS USA UA-5200 Series User Manual Manual pdf 147 page image

UA-5200 Series User Manual V4.3 ICP DAS1476.3. Modbus ASCII (Master)This setting is for UA Controller connecting the remote Modbus ASCII Slave module.This page is for setting the communication values with the connected modules. Firstchoose the serial port that connected with the module, and each module can give a name(Default name: Name). Click [ ] button could add a new module, and then click [Edit]button to configure the module content and the Modbus mapping table.Setting Steps:1. Select the module connecting Serial port2. Give the module name or nickname, e.g. Example2. Default: Name3. Click the button [ ] to add a new module4. Click the button [Edit] to enter the Module Content Setting page5. Set up the Modbus Mapping Table for the UA controller and module I/O channels2. Give a name, ex: Example23. Click to add1. Select the connecting serial port4. Click to set the module content