Husqvarna Zenoah LHTZ-A Owner's Manual

Compatible ModelsPHT750/PHT1200/PHT1500DANGERKeep blades away from power lines. Accidental cutting of power lines could result in inju-ry and even death due to electrical shock.WARNINGThe blades used in this product are very sharp. Failure to handle the product correctlycould result in serious injury. Observe all precautions to ensure correct operation of theproduct.● Do not direct the blades toward people.● Turn off the engine before changing the blade angle or removing debris caught inthe blades.● Wear thick, durable leather gloves when using the product and when performing in-spections and maintenance.● Cover the blades with the included cover when the product is not in use.● Falling branches and chips could cause injury to the face and eyes. Wear a helmetand face protector when using the product.● Refer to the instruction manual of the main device for information on using the maindevice.IMPORTANT● When using this attachment with cutters having engines of 25cc or more displacement, open thethrottle only partially as such engines produce too much power for suitable operation of this attach-ment.● This product contains an overload protection mechanism to prevent damage to blades and drivegears due to excessive force.Note the following precautions if branches frequently get caught in the blades.※ Branch thickness: Try not to cut branches more than 5mm or so in thickness.※ Blade condition: Using worn blades results in a loss of cutting ability and increases likeliness ofcaught branches.● Do not allow blades to remain wet. Do not allow the drive unit to become wet. Doing so may result inrust or failure.■ Attachment Installation(1) Loosen the setting screw and gear casemounting bolt for the gear case of the weedcutter. Then remove the gear case.(2) Remove the partially tightened setting screwin the attachment mount.(3) Place the attachment mount over the mainpipe of the cutter. Refer to Fig. 1.(4) Align the setting screw hole with the hole inthe main pipe and then fully tighten the set-ting screw.(5) Use a 4-mm Allen wrench to fully tighten theattachment mounting bolt.Zenoah Hedge Trimmer Attachment for Weed CuttersOWNER’S MANUAL115869126 (1610)Fig. 1Main pipeSetting screwHoleAttachmentMountAttachmentmounting bolt*LHTZ-A 取説_CS5_二.indd 1 16/10/21 16:26

/ 2

Related manuals for Husqvarna 580720601