Husqvarna Z 242F Operator's Manual

Also see for Z 242F: Operator's manual Operator's manual Operator's manual Operator's manual Operator's manual

26©2014 Al4riGeneralRemove the ignition key to prevent unintentional movementsduring lubrication.When lubricating with an oil can, it must be filled with engineoil.When lubricating with grease, unless otherwise stated, use ahigh grade molybdenum disulphide grease.For daily use, the machine should be lubricated twice weekly.Wipe away excess grease after lubrication.It is important to avoid getting lubricant on the belts orthe drive surfaces of the belt pulleys. Should this happen,attempt to clean them with spirits. If the belt continues to slipafter cleaning, the belt must be replaced. Gasoline or otherpetroleum products must not be used to clean belts.12/12 Every year Lubricate withgrease gun1/52 Every Week Filter change1/365 Every day Oil changeLevel checkIMPORTANT INFORMATION Use minimal lubricationand remove excess lubricant so that is does not come intocontact with belts or belt pulley drive surfaces.TransmissionThe transmission is maintenance free with no need for levelchecks or oil changes. If a leak occurs, replace the unit orcontact your Husqvarna dealer.Wheel and Deck ZerksUse only good quality bearing grease.Grease from well-known brand names (petrochemicalcompanies, etc.) usually maintains a good quality.Front Wheel MountLubricate 3-4 strokes with a grease gun on each set of wheelbearings.Front Wheel BearingsLubricate 3-4 strokes with a grease gun on each set of wheelbearings.Deck SpindlesLower the cutting deck completely.Lubricate with a grease gun, 2-3 strokes per spindle.

/ 40

This manual is suitable for:

Z 242F

Husqvarna Z 242F Operator's Manual

Product

Learn More

Legal