Husqvarna YTH1848 Owner's Manual

Also see for YTH1848XP: Owner's manual Owner's manual Owner's manual

802510INSTALL MOWER AND DRIVE BELT(See Figs. 6 and 7)Be sure tractor is on level surface and mower suspensionarms are raised with attachment lift control. Engage park-ing brake.• Cut and remove ties securing anti-sway bar and belts.Swing anti-sway bar to left side of mower deck.• Slide mower under tractor with deflector shield to rightside of tractor.IMPORTANT: Check belt for proper routing in all mowerpulley grooves.• If equipped, turn height adjustment knob counter-clockwise until it stops.ASSEMBLYFIG. 5TO ATTACH NOSE ROLLER (See Fig. 5)• Assemble brackets "A" and "B" to the inside of mowermounting brackets as shown. Tighten securely.NOTE: Be sure bracket tabs are positioned in tab holesin mower brackets.• Position nose roller between brackets and install rodand retainer spring.02612NOSEROLLERHEXBOLT"A"BRACKETLOCKNUTTABHOLERETAINER SPRINGROD"B"BRACKET• Lower mower linkage with attachment lift control.• Be sure belt tension rod is in disengaged position.Install belt into electric clutch pulley groove.• Place the suspension arms on outward pointing deckpins. Retain with double loop retainer spring with loopsup as shown.• Install front plate assembly to tractor suspensionbrackets and retain with single loop retainer springsas shown.• Position front plate assembly between front mowerbrackets. Raise deck and plate assembly to align holesand insert flanged pins. Secure pins with double loopretainer springs between the plate assembly and mowerbrackets.NOTE: To assist in locating hole in flanged pin, the hole inpin is inline with notch on head of pin. If necessary, movemower side-to-side to give space between plate and mowerbrackets.IMPORTANT: Check belt for proper routing in all mowerpulley grooves. Engage belt tension rod by pushing rodinto locking bracket.• Engage belt tension rod by pushing rod into lockingbracket.CAUTION: Belt tension rod is springloaded. Have a tight grip on rod andengage slowly.• Connect anti-sway bar to chassis bracket under leftfootrest and retain with double loop retainer spring.• If equipped, turn height adjustment knob clockwise toremove slack from mower suspension.• Raise deck to highest position.• Adjust gauge wheels before operating mower as shownin the Operation section of this manual.ANTI-SWAYBARSINGLE LOOPRE TAIN ER SPRINGSGAUGE WHEELSUSPENSION ARMSDOUBLE LOOPRE TAIN ER SPRINGFRONT SUSPENSIONBRACKETSFRONT PLATEAS SEMBLYCHASSISBRACKETDOUBLE LOOP RETAINERSPRING (OUTWARDPOINT ING DECK PINS)ELECTRIC CLUTCHPULLEYDE FLECTOR SHIELDUSE PLIERS FORRETAINER SPRINGSLOOP UPFRONTMOWERBRACKETBELT TENSION ROD(DISENGAGED POSITION)LOCK BRACKETFLANGEDPINDOUBLE LOOPRE TAIN ER SPRINGFIG. 6