Husqvarna YTH1542XP Owner's Manual

Also see for YTH1542XP: Owner's manual Owner's manual Owner's manual Owner's manual Owner's manual

Contents

1400272FIG. 10MOWING TIPS• Mower should be properly leveled for best mowing per-formance. See “TO LEVEL MOWER HOUSING” in theService and Adjustments section of this manual.• The left hand side of mower should be used for trim-ming.• Drive so that clippings are discharged onto the areathat has been cut. Have the cut area to the right of themachine. This will result in a more even distribution ofclippings and more uniform cutting.• When mowing large areas, start by turning to the right sothat clippings will discharge away from shrubs, fences,driveways, etc. After one or two rounds, mow in theopposite direction making left hand turns until finished(See Fig. 10).OPERATION• Place tractor safely on level surface with engine off andparking brake set.• Disengage transmission by placing freewheel controlin freewheeling position (See “TO TRANSPORT” in thissection of manual).• Sitting in the tractor seat, start engine. After the engineis running, move throttle control to slow position. Withmotion control lever in neutral (N) position, slowly dis-engage clutch/brake pedal.• Move motion control lever to full forward position andhold for five (5) seconds. Move lever to full reverseposition and hold for five (5) seconds. Repeat thisprocedure three (3) times.NOTE: During this procedure there will be no movementof drive wheels. The air is being removed from hydraulicdrive system.• Move motion control lever to neutral (N) position. Shut-off engine and set parking brake.• Engage transmission by placing freewheel control indriving position (See “TO TRANSPORT” in this sectionof manual).• Sitting in the tractor seat, start engine. After the engineis running, move throttle control to half (1/2) speed.With motion control lever in neutral (N) position, slowlydisengage clutch/brake pedal.• Slowly move motion control lever forward, after the tractormoves approximately five (5) feet, slowly move motioncontrol lever to reverse position. After the tractor movesapproximately five (5) feet return the motion control leverto the neutral (N) position. Repeat this procedure with themotion control lever three (3) times.• Your transmission is now purged and now ready fornormal operation.• If grass is extremely tall, it should be mowed twice toreduce load and possible fire hazard from dried clip-pings. Make first cut relatively high; the second to thedesired height.• Do not mow grass when it is wet. Wet grass will plugmower and leave undesirable clumps. Allow grass todry before mowing.• Always operate engine at full throttle when mow-ing to assure better mowing performance and properdischarge of material. Regulate ground speed by se-lecting a low enough gear to give the mower cuttingperformance as well as the quality of cut desired.• When operating attachments, select a ground speedthat will suit the terrain and give best performance ofthe attachment being used.