Husqvarna W25P Operator's Manual

11Inspect all screws/nuts/boltsCheck the hoses and fittingsClean for any debrisInspect and clean the fuel tankInspect and clean the fuel filterInspect and clean the air cleanerEmpty the fuel tankClean or re-adjust the spark pluggapMake sure the gap is0.6-0.7mm (.025in).Replace if necessaryInspect the muffler for damage.Check the impeller and impellerclearance.Check the pump inlet valve.Replace if necessaryClean the muffler and the cylinderexhaust portClean the cylinder fins and intake aircooling fanCheck the operation of the throttlelever and stop switchEnginePumpTighten or replace if necessary.Adjusting screws are notincluded.√√√√√√√√√√√√√√Maintenance scheduleMake sure you obey the maintenance schedule. The intervals are calculated from daily use of the product.The intervals are different if you do not use the product every day. Only do maintenance written in thismanual. Speak to an approved service center about other maintenance not found in this manual.√√Maintenance procedureInspect the whole unit for damage,leakage or spillageInspect all accessible fasteners Tighten or replace if necessaryDailyOverallWeekly Monthly Note