Husqvarna ST 227P Operator's Manual
Also see for ST 227P: Instruction manualOperator's manualOperator's manualOperator's manual
9CHOKE CONTROLTRUCTIONSOPERATIONTO CONTROL SNOW DISCHARGE (See Fig. 11)WARNING: Snow throwers have ex-posed rotating parts, which can causesevere injury from contact, or from ma-terial thrown from the discharge chute.Keep the area of operation clear of allpersons, small children and pets at alltimes including startup.WARNING: If the discharge chute or au-ger become clogged, shut-off engineand wait for all moving parts to stop. Usethe clean-out tool, NOT YOUR HANDS,to unclog the chute and/or auger.The operation of any snow thrower can resultin foreign objects thrown into the eyes, whichcan result in severe eye damage. Always wearsafety glasses or eye shields while operatingyour snow thrower or performing any adjust-ments or repairs. We recommend standard safety glassesor a wide vision safety mask worn over spectacles.HOW TO USE YOUR SNOW THROWERKnow how to operate all controls before adding fuel orattempting to start the engine.STOPPINGTRACTION DRIVE• Release traction drive control lever to stop the forwardor reverse movement of the snow thrower.AUGER• Release the auger control lever to stop throwing snow.ENGINE1. Move ON / OFF switch to “OFF” position.2. Remove (do not turn) safety ignition key to preventunauthorized use.NOTE: Never use choke to stop engine.FIG. 11FIG. 10DISCHARGE CHUTECONTROL LEVERCHUTE DEFLECTORREMOTE CONTROLLEVERTO THROW SNOW (See Fig. 12)The auger rotation is controlled by the auger control leverlocated on the right side handle.• Squeeze auger control lever to handle to engage theauger and throw snow.• Release the auger control lever to stop throwing snow.AUGERCONTROLLEVERCHOKECONTROLFIG. 12The DIRECTION in which snow is to be thrown is controlledby the discharge chute control lever.• To change the discharge chute position, pull backwardon discharge chute control lever and move lever leftor right until chute is in desired position. Be sure leversprings back and locks into desired position.The DISTANCE that snow is thrown is controlled by theposition of the chute deflector. Set the deflector low tothrow snow a short distance; set the deflector higher tothrow snow farther.• Push right on chute deflector control lever and movelever forward to lower the deflector and decrease thedistance. Move lever back to raise the deflector andincrease the distance. Be sure lever springs back andlocks into desired position.TO USE FUEL SHUT-OFF VALVE (See Fig. 9)The fuel shut-off valve is located beneath the fuel tank onthe engine. Always operate the snow thrower with the fuelshut-off valve in the OPEN position.TO USE CHOKE CONTROL (See Fig. 10)The choke control is located on the engine. Use the chokecontrol whenever you are starting a cold engine. Do notuse to start a warm engine.• To engage choke, rotate lever clockwise to “FULL”position.FIG. 9OFFONFUELCONTROLINSTRUCTIONS |
This manual is suitable for:
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved