Husqvarna S 13 Operator's Manual

Also see for S 13: Operator's manual Operator's manual Operating manual Operator's manual Manual

• This machine is designed for picking up dry, non-flammable dust and debris in an indoor environment.It is not suitable for picking up liquids.• Do not pick up any type of liquids.• Do not allow a build-up of dust, hair and anythingthat may reduce airflow.• Keep hair, loose clothing, fingers and all parts ofbody away from openings and moving parts.• Use extra care when cleaning on stairs.• Do not use the product without dust bag and/ orfilters in place. Replace collection system and/orfilters as described in this manual.• Turn of all controls before unplugging.Personal protective equipmentWARNING: Read the warning instructionsthat follow before you use the product.• Always use approved personal protective equipmentduring operation. Personal protective equipmentdoes not give you full protection but it decreases thedegree of injury if an accident occur. Speak to youservicing dealer for recommendations about whichequipment to use.• Use approved protective gloves when youmaintenance the product.Work area safetyWARNING: Read the warning instructionsthat follow before you use the product.• Do not use outdoors or on wet surface, this productis for indoor use only.• Do not expose the product to rain and moisture,store indoors only.Safety instructions for maintenanceWARNING: Read the warning instructionsthat follow before you use the product.• Make sure the engine switch is in the Off position.Disconnect the product from the wall outlet.• Do not modify the product from its original design.• All repairs must be performed by a qualified serviceperson. Use only manufacturer-supplied orequivalent replacement parts.• Use approved protective equipment. Refer toPersonal protective equipment on page 16• Do not make a hole in the HEPA filter. A brokenHEPA filter can disperse dust.AssemblyGeneralDo a check that the following accessories are included:• The hose with end fittings• Steel tube• Floor Nozzle• Multi adapter (only S 13/S 26)If 1 of the parts is missing, speak to your local serviceagent or salesman.For models that do not have the front casters assembledbecause of the limit of package:• Assemble the front casters using the bolt or the nutand the washer included in the package.Make sure to dispose the package and the used productcomponents in correct procedure. Refer to local disposalregulations. Make sure to recycle.To attach the suction hoseThere is a hose intake with a hose lock on the product.The hose lock makes sure that the suction hose adapterdo not fall off.1. Lift the hose lock and attach the suction hoseadapter.2. Lower the hose lock into the recess of the adapter.To attach the nozzle on the hand pipeThe floor nozzle has adjustable wheels. Adjust thewheels to get the best suction effect. Adjust the wheelswith the knob, which is on the rear side of the nozzle.The wheels and rubber strips of the nozzle can bereplaced. Keep the nozzle in good condition.OperationIntroductionWARNING: Before you operate the product,carefully read and understand the safetychapter and the operation instructions.Before useWARNING: Before using the dust extractormake sure that the power and voltagecorresponds with the voltage shown on the16 896 - 004 -