Husqvarna Rider 318 Operator's Manual

Also see for Rider 318: Operator's manual Operator's manual Operator's manual

WARNING: Remove grass, leaves and otherflammable materials from the product todecrease the risk of fire. Let the productbecome cool before you put it in storage.• Clean the product, seeTo clean the product on page17. Repair paint damages to prevent corrosion.• Examine the product for worn or damaged parts andtighten loose screws and nuts.• Remove the battery. Clean it, charge it, and keep itcool during storage.• Change the engine oil, and discard the waste oil.• Empty the fuel tank. Start the engine and run it untilthere is no remaining fuel in the carburetor.Note: Do not empty the fuel tank and carburetor if astabilizer has been added.• Remove the plugs and put about a tablespoon ofengine oil into each cylinder. Manually turn theengine shaft to apply the oil and put the plugs backon.• Lubricate all grease nipples, joints and axles.• Keep the product in a clean and dry area and coverit for more protection.• A cover for protection of your product during storageor transport is available at your dealer.Disposal• Used engine oil, antifreeze etc. is dangerous andmust not be discarded on the ground or in nature.Always discard used chemicals at a service center oran applicable disposal location.• When the product is worn out and no longer used,send it back to the dealer or to an applicablerecycling location.• Be careful with oil, oil filters, fuel and the battery,because of the possible effects on the environment.Obey the local recycling requirements and applicableregulations.• Do not discard the battery as domestic waste.• Send the battery to a Husqvarna service agent ordiscard it at a disposal location for used batteries.28 246 - 001 - 04.10.2017