Husqvarna Rider 15V2 Workshop Manual

Also see for Rider Pro 15: Operator's manual Operator's manual Operator's manual Operator's manual Workshop manual

Contents

English – 11Delivery measuresWARNING!The battery acid is highly corrosive. Userubber gloves and protective glasses. Avoidbreathing in the acid fumes.Measures for contact with acidExternal: Rinse thoroughly with water.Internal: Drink large quantities of water ormilk. Contact a doctor as soon aspossible.Eyes: Rinse thoroughly with water.Contact a doctor as soon asap.The battery gives off explosive gas. Sparks,naked flames and cigarettes must absolutelynot be in the near vicinity of the battery.BatteryThe battery is delivered dry-charged from thefactory. The cells are fitted with sealing film. Thebattery plugs are packed in a plastic bag.• Fill the battery cells slowly with battery acid tothe max. level mark on the battery container.• Wait 20 minutes and top up with battery acid ifnecessary.• Charge the battery with 12 V max. 6 A for 4hours.• Check the electrolyte level and top up ifnecessary with distilled water to the top levelmarks on the battery container.Put the battery in position.Connect the battery with the screws and nuts fittedon the battery. Brace the screws when fitting toavoid exposing the terminals to strain.• Black cable is connected to -.• Red cable is connected to +.Make sure the cables do not rub against thematerial.Fit the cover over the battery and tighten the strap.For Husqvarna Parts Call 606-678-9623 or 606-561-4983www.mymowerparts.com