Husqvarna QTB380W User Manual

It must be possible todisconnect the appliancefrom the mains powersupply. The plug musttherefore be easilyaccessible after installation.3.3 PositioningThis appliance is not intended to beused as a built-in appliance.This appliance should be installed in adry, well ventilated indoor position.This appliance is intended to be used atambient temperature ranging from 10°Cto 43°C. The correct operation of theappliance can only be guaranteed withinthe specified temperature range.If you have any doubtsregarding where to installthe appliance, please turn tothe vendor, to our customerservice or to the nearestAuthorised Service Centre.3.4 Electrical connection• Before plugging in, ensure that thevoltage and frequency shown on therating plate correspond to yourdomestic power supply.• The appliance must be earthed. Thepower supply cable plug is providedwith a contact for this purpose. If thedomestic power supply socket is notearthed, connect the appliance to aseparate earth in compliance withcurrent regulations, consulting aqualified electrician.• The manufacturer declines allresponsibility if the above safetyprecautions are not observed.• This appliance complies with theE.E.C. Directives.3.5 Handle installation guide1. Take out the handle base and 4screws from the plastic bag.2. Place the handle in positionaccording to the picture. Use Phillipsscrewdriver to fix the handle base tothe lid.3. Take out the handle cover from theplastic bag. Press it to the front sideof the handle base. Make sure thatthe fasteners of the handle cover arealigned with the assembly holes ofthe handle base.Open and close the lid several times tomake sure the handle is properlyfastened.4. GENERAL OVERVIEWENGLISH 25