Husqvarna PP 492 Operator's Manual

Also see for PP 492: Operator's manual Operator's manual

3. Push and hold the "RETURN" button (A) and turnthe dial (B) clockwise to rotate the blade/wire.OKON/OFF0AB4. Push the machine stop button on the power packunit to stop the blade.5. Make sure that the power indicator on the productgoes out.6. Do the same procedure to make a check of the stopbutton on the remote control.RCDThe product has an integrated RCD. The RCD is aprotection for the operator if an electrical fault occur.To do a check of the residual-current deviceWARNING: Always do a test of the residual-current device before use.1. Connect the product to a grounded 3-phase outletsocket.2. Open the cover of the residual-current device to getaccess to the power switch (A) and the test button(B).A B3. Push the power switch of the residual-current deviceto 1.4. Push the test button. The residual-current devicemust release to disconnect the unit from the powersupply.5. Reset the residual-current device. Push the powerswitch of the residual-current device to 0 and then to1.6. Close the cover.Safety instructions for maintenanceWARNING: Read the warning instructionsthat follow before you do maintenance onthe product.• Not approved changes and/or accessories cancause serious injury or death to the operator orothers.• Do the daily maintenance to make sure that theproduct operates correctly. Refer toMaintenance onpage 14.• Do the inspection and/or maintenance with the motorstopped and the power plug disconnected.• Clean the product with water. Do not use highpressure washer. Do not point the water at electricalcomponents or bearings.• All repairs must be done by an approved serviceperson. Use only Husqvarna or equivalentreplacement parts.OperationIntroductionWARNING: Before you operate the product,you must read and understand the safetychapter.967 - 001 - 04.02.2020 7