Husqvarna MZ61 Operator's Manual

GeneralRemove the ignition key to prevent unintentional movementsduring lubrication.When lubricating with an oil can, it must be filled with engineoil.When lubricating with grease, unless otherwise stated, use ahigh grade molybdenum disulphide grease.For daily use, the machine should be lubricated twice weekly.Wipe away excess grease after lubrication.It is important to avoid getting lubricant on the belts or thedrive surfaces on the belt pulleys. Should this happen, attemptto clean them with spirits. If the belt continues to slip aftercleaning, it must be replaced. Gasoline or other petroleumproducts must not be used to clean belts.12/12 Every year Lubricate withgrease gun1/52 Every Week Filter change1/365 Every day Oil changeLevel checkIMPORTANT INFORMATION Use minimal lubricationand remove excess lubricant so that is does not come intocontact with belts or belt pulley drive surfaces.Deck SpindlesLower the cutting deck completely.If a grease gun without rubber hose is used, the foot platemust be removed to access the center spindle.Lubricate with a grease gun, 2-3 strokes per spindle.Wheel and Deck ZerksUse only good quality bearing grease.Grease from well-known brand names (petrochemicalcompanies, etc.) usually maintains a good quality.Front Wheel MountLubricate 3-4 strokes with a grease gun on each set of wheelbearings.Front Wheel BearingsLubricate 3-4 strokes with a grease gun on each set of wheelbearings.28LUBRICATION