Husqvarna K 7000 Operator's Manual

Also see for K 7000: Operator's manual Workshop manual Workshop manual Operator's manual Operator's manual

4. Remove the belt from the pulley.Note: The cutting head can be removed from theproduct.5. Loosen the 2 screws that hold the belt guard.6. Remove the rear belt guard.7. Replace the drive belt.8. Assemble in opposite sequence. To install thecutting blade, refer toTo install the cutting blade onpage 14.Transportation, storage and disposalTransportation and storage• Secure the product during transportation to preventdamage and accidents.• Remove the cutting blade before transportation orstorage of the product.• Keep the product in a locked area to prevent accessfor children or persons that are not approved.• Keep the cutting blades in dry, frost free conditions.• Examine all new and used blades for transport andstorage damage before assembly.DisposalSymbols on the product or the packaging of the productindicate that this product cannot be handled as domesticwaste. It must be submitted to an appropriate recyclingstation for the recovery of electrical and electronicequipment.By ensuring that this product is taken care of correctly,you can help to counteract the potential negative impacton the environment and people that can otherwise resultthrough the incorrect waste management of this product.For more detailed information about recycling thisproduct, contact your municipality, your domestic wasteservice or the shop from where you purchased theproduct.24 1448 - 003 - 13.02.2020