Husqvarna GT48XLSi Operator's Manual

Contents

21SERVICE AND ADJUSTMENTSFig. 29TO REMOVE MOWER (See Fig. 29)• Place attachment clutch in “DISENGAGED” position.• Lower attachment lift lever to its lowest position.• Remove mower belt from electric clutch pulley (M). SeeMower Drive Belt Removal in "TO REPLACE MOWERBLADE DRIVE BELT" in this section.• Disconnect front link (E) from mower - remove retainerspring and washer.• Go to either side of mower and disconnect mowersuspension arm (A) from chassis and rear lift link (C)from rear mower bracket (D) - remove retainer springsand washers.• Go to other side of mower and disconnect the suspen-sion arm and rear lift link.CAUTION: After rear lift links are discon-nected, the attachment lift lever will bespring loaded. Have a tight grip on liftlever when changing position of the lever.• Slide mower out from under right side of tractor.TO INSTALL MOWER (See Fig. 29 - 36)Ensure tractor is on level surface and engage parking brake.• Lower attachment lift lever to its lowest position.CAUTION: Lift lever is spring loaded.Have a tight grip on lift lever, lower itslowly and engage in lowest position.NOTE: Ensure mower side suspension arms (A) are point-ing forward before sliding mower under tractor.• Slide mower under tractor until it is centered undertractor.EA MQFBCSOHDDP90° END INTEGRATED WASHER ENDANTI-SWAY BAR (S)TOWARDS TOWARDSTRANSAXLE MOWER DECKINSTALL ANTI-SWAY BAR (S) (IF EQUIPPED)Fig. 30WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:• Depress brake pedal fully and set parking brake.• Place attachment clutch in “DISENGAGED” position.• Shut engine off and lock the SmartSwitch Ignition.• Make sure the blades and all moving parts have completely stopped.• Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.