Husqvarna DS 500 Operator's Manual

Also see for DS 500: Operator's manual Operator's manual

Contents

AssemblyIntroductionThis section describes how to assemble and adjust theproduct.WARNING: Before you assemble theproduct, read the safety chapter and theassembly instructions.To attach the wheel kit (accessory)1. Attach the wheel kit on the rear side of the bottomplate.2. Tighten the screw.To attach the drill motorWARNING: Always pull out the plug from theoutlet socket before cleaning, maintenanceor assembly.1. Unlock the drill motor carriage (A).2. Attach the drill motor in the track (B) on the drillmotor carriage.3. Lock the drill motor carriage (A).ABQuick spacer (accessory)Use a quick spacer to drill large hole diameters. Toselect the correct quick spacer, refer toMaximum drilldiameter on page 13. Assemble the quick spacer onthe drill motor before you attach the drill motor to the drillstand.To replace the drill stand column(assessory)1. Push the stop plate to open position. Remove thedrill motor carriage.6 922 - 002 - 06.03.2019