Husqvarna DM1 PACE Operator's Manual

Also see for DM1 PACE: Operator's manual

• This device may not cause harmful interference• This device must accept any interference received,including interference that cause undesiredoperation.Le présent appareil est conforme aux CNR d'IndustrieCanada applicables aux appareils radio exempts delicence. L'exploitation est autorisée aux deux conditionssuivantes:• l'appareil ne doit pas produire de brouillage, et• l'appareil doit accepter tout brouillage radioélectriquesubi, même si le brouillage est susceptible d'encompromettre le fonctionnement.AssemblyIntroductionWARNING: Before you assemble theproduct, read the safety chapter.WARNING: To prevent accidental startduring assembly, disconnect the batteryfrom the product.To attach the product to a drill standCAUTION: Read the operator's manualfor the drill stand carefully.• To attach the product to a drill stand, refer to themanual for the drill stand.• Use only with approved Husqvarna drill stands.OperationIntroductionWARNING: Read and understand thesafety chapter before you use the product.To do before you operate the product1. Read the operator's manual for the drill motorcarefully and make sure that you understand theinstructions.2. Read the operator's manual for the drill standcarefully and make sure that you understand theinstructions.3. Do the daily maintenance. Refer toMaintenanceschedule on page 18.4. Use personal protective equipment. Refer toPersonal protective equipment on page 8.5. Make sure that the work area is clean and bright.6. Make sure that the product is installed correctly. Thedrill bit and the drill stand must be attached correctly.7. When you do inverted drilling, make sure that youcomply to the applicable instructions. Refer toToprepare the product for inverted drilling on page 12.8. Make sure that the water system is not damagedand that it is connected to the product.1941 - 005 - 25.09.2023 11