Husqvarna BMG 555 P Operator's Manual

3. Apply a soap mixture as a spray at all lines andconnections. For soap mixture use 50% soap and50% water.4. If there is a leak, there will be bubbles on the linesand the connections. Speak to an approved serviceagent.To fill the propane tankCAUTION: Examine the propane tankand lines each time the propane tank is filledand/or connected to the product. Refer toToconnect and disconnect the propane tank onpage 11.Do not fill the propane tank too much. The propane tankcan hold a maximum of 9 kg/20 lbs of propane. A fullpropane tank must not weigh more than 21.8 kg/48 lbs.If the propane tank is filled too much, frost shows on thepropane lines or on the regulator.1. Stop the product. Refer toTo stop the product onpage 13.2. Make sure that the propane tank valve is closed.3. Remove the propane tank from the product.4. Fill the propane tank with new propane or replacethe propane tank.5. Install the filled/new propane tank to the product.Refer toTo connect and disconnect the propanetank on page 11.6. If the weather is cold, keep the product indoorsbefore use to warm up the propane tank. You canalso use a propane tank heat blanket to warm up thepropane tank.To fill the propane tankCAUTION: Examine the propane tankand lines each time the propane tank is filledand/or connected to the product. Refer toToexamine the propane tank and lines on page15.Do not fill the propane tank too much. The propane tankcan hold a maximum of 9 kg/20 lbs of propane. A fullpropane tank must not weigh more than 21.8 kg/48 lbs.If the propane tank is filled too much, frost shows on thepropane lines or on the regulator.1. Stop the product. Refer toProduct liability on page 4.2. Make sure that the propane tank valve is closed.3. Remove the propane tank from the product.4. Fill the propane tank with new propane or replacethe propane tank.5. If the propane tank is filled too much, use ascrewdriver at the propane tank valve to releaseunwanted propane. Release the propane in a safeprocedure, refer toPropane safety on page 5.6. Install the filled/new propane tank to the product.Refer toTo connect and disconnect the propanetank on page 11.7. If the weather is cold, keep the product indoorsbefore use to warm up the propane tank. You canalso use a propane tank heat blanket to warm up thepropane tank.To do a check of the engine oil level1. Park the product on level ground and stop theengine.2. Loosen the dipstick and pull it out.3. Clean the oil from the dipstick.4. Put the dipstick in the hole for the dipstick andtighten it.5. Loosen and pull the dipstick out and read the oillevel.6. The oil level must be between the marks on thedipstick. If the level is near the ADD mark, fill oil tothe FULL mark.16 1991 - 001 - 02.06.2023