Husqvarna AUTOMOWER 105 Operator's Manual

Also see for 315, 320: Operator's manual Operator's manual Quick guide Operator's manual Operator's manual

Note: Battery life is dependent on the lengthof the season and how many hours a day theproduct is operating. A long season or manyhours of use a day means that the batterymust be replaced more regularly.Contact your local Husqvarna representativeto replace the battery.5.3 Replace the bladesWARNING: Use blades andscrews of the right type. Husqvarnacan only guarantee safety whenusing original blades. Only replacingthe blades and reusing the screwcan result in a screw wearing duringmowing. The blades can then bepropelled from under the body andcause serious injury.Replace worn or damaged parts for safetyreasons. Even if the blades are intact, theyshould be replaced on a regular basis for thebest mowing result and low energy usage. All3 blades and screws must be replaced at thesame time to obtain a balanced cuttingsystem. Use Husqvarna original bladesembossed with the crowned H-mark logotype,refer toWarranty terms on page 34.5.4 To replace the blades1. Switch off the product with the mainswitch or the ON/OFF button.2. Turn the product upside down. Place theproduct on a soft and clean surface toavoid scratching the body and the hatch.3. Rotate the skid plate so that its holesalign with the screws for the blade.4. Remove the 3 screws. Use a straight slotor cross-tip screwdriver.5. Remove each blade and screw.6. Fasten new blades and screws.7. Check that the blades can pivot freely.6 Troubleshooting6.1 TroubleshootingIn case of malfunction, a message will appear on the display. For more detailed information onmessages, refer to the complete Operator’s manual on Husqvarna’s website(www.husqvarna.com. If the same message appears often or if you still cannot find the reasonfor the fault, contact your local Husqvarna representative.Breaks in the loop wire are usually the result of unintentional physical damage to the wire suchas when gardening with a shovel. Breaks can also be due to the wire being stretched excessivelyduring installation. A wire break can be located by gradually halving the distance of the loopwhere the break may have occurred, until there is only a very short section of the wire left. Referto the complete Operator’s manual on Husqvarna’s website (www.husqvarna.com).1418 - 001 - 04.12.2019 Troubleshooting - 23