Husqvarna 96727750400 Operator's Manual

Fuses are located on the left hand side of themachine and are accessed by tilting the seatforward. Fuses are flat pin fuses type as used inautomobiles. The 20 A is the primary fuse. The7.5 A is for the mower deck coupling.Fuel Shut Off ValveThe fuel shut off valve is located at the left rear ofthe seat. The valve is off when the handle tab isturned perpendicular to the fuel line.IMPORTANT INFORMATION Always raise thedeck to the highest position for transport.Cutting Height PedalThe desired cutting height is set with the heightpin. The cutting height pedal releases the deck liftto place the deck at the selected height.For transport, push the lift pedal fully forwarduntil the deck lift latches in the transport (highest)position.TrackingIf the mower is not tracking straight, check theair pressure in both rear tires. Recommended airpressure for the rear tires is 15 psi (1 bar).1. Tracking adjustments are made using thetracking bolt and tracking knob. The trackingbolt and tracking knob act as limiting devicesfor the motion control levers when in the full-forward position.2. For preliminary tracking adjustment, moveunit to an open, unobstructed area such as anempty parking lot or open field.3. Back the tracking bolt out until flush with nut.4. Loosen tracking knob out until flush with nut.5. Test operate unit by driving it at full throttle andthe full forward position on both motion controllevers. Gradually turn in the tracking bolt onthe right hand side until the unit noticeablystarts drifting right.6. Drive forward at full throttle with both motioncontrol levers in the full forward position.Gradually turn in the tracking knob (left side)until unit tracks straight.Fuses15CONT R OLS