Husqvarna 536LiL Workshop Manual

Also see for 136LiC: Operator's manual Operator's manual Workshop manual

Contents

5.6 To replace the handle1. Loosen the knob LiL, LiLX/iLX or the wing nut LiC/iCand remove the parts from the shaft.2. Assemble the new parts between the spacer and theshaft.LiC, iCOnly LiLX, iLXLiL, LiLX, iLX5.7 To replace the shaft1. Disassemble the handle and the operating handle.SeeOperating handle on page 372. Disassemble the wear guard below the batteryhousing. SeeTo remove the wear guard from thebattery housing on page 363. Disassemble the battery housing. SeeTodisassemble the battery housing on page 374. Disassemble the trimmer line. SeeTrimmer linereplacement on page 175. Disassemble the motor. SeeTo disassemble themotor on page 226. Remove the 4 screws and the plate that hold theshaft.7. Replace the shaft and the plate if it is necessary.8. Assemble the product in opposite sequence.5.8 To disassemble the wear guardCAUTION: Make a note of how the wires andcomponents are put before you disassemble.737 - 002 - 25.10.2018 Repair instructions - 21