Husqvarna 36 Operator's Manual

Also see for 36: Workshop manual Operator's manual

Fuelmixand chainoil~ WARNING! The chain saw is equipped with a two-strokeengine. Always run the saw with fuel, which is mixed with oil.Provide for good ventilation, when fueling or handling fuel.(.–-->” ‘ \,M’‘-Q,, “ hJ!Erp~.. ‘..> ~ .\,.—.. ‘Gl\FuelAlways use a regular unleaded gasoline with minimumoctane number of 90.This engine is certified to operate on unleaded gasoline.Two-stroke oil.......For the best performance, use Husqvarna two-stroke oil, whichis especially developed for chain saws.Mixing ratio 1:50 (2 0/0),If Husqvarna two-stroke oil is not available, you may useanother two-stroke oil of good quality.Mixing ratio 1:33 (3%).In countries where no two-stroke oil is available, motor oil SAE30 can be used. Mixing ratio 1:25 (4%).Never use multi-grade oil (1OW-30) or waste oil.Always mix fuel and oil in a clean container.Always start by filling half the amount of fuel, which is to beused, Then add the whole amount of oil. Mix (shake) the fuelmixture, Add the remaining amount of fuel,Mix (shake) the fuel mix thoroughly before filling the fuel tankon the saw.99:Min 3 m m(lo ft) mm*fcim f)bGasolinBenzin Oil .01. Huile . AceiteEssence Lit.GasolinaLit 2%(1 :50) 3“/0(1:33) 4%(1 :25) 5%(1:20)5 0,10 0,15 0,20 0,2510 0,20” 0,30 0,40 0,5015 0,30 0,45 0,60 0,7520- 0,40 0,60 0,80 1,00Chain oill The chain lubrication svstem is automatic, Alwavs use s~ecialchain oil with oood adhesive characteristics. ‘...l.In countries w;ere no special chain oil is available, gear box oilEP 90 can be used,Never use waste oil. This results in damage to the oil pump, thebar and the chain.It is important to use oil of the right viscosity according to the atemperature.In temperatures below OOC(320F)some oils become lessviscous. This can overload the oil pump and result in damageto the oil pump components.Contact your servicing dealer when choosing chain oil.FuelingI i~ WARNING!l Always shut off the engine before refueling.l Slowly open the fuel tank, when filling up with fuel, so thatpossible over- pressure disappears.l Tighten the fuel cap carefully, after fueling.l Always move the saw away from the fueling area beforestarting.Before fueling, clean the tank cap area carefully, to ensure thatno dirt falls into the tank and causes malfunction. Make sure thatthe fuel is well mixed by shaking the container, before fueling.The volume of the chain oil tank and the fuel tank are adjusted toeach other. Therefore, always fill up with chain oil and fuel at thesame time.D& Chain oil