Husqvarna 2620199902168 Information

5 ENGLISHITALIANOFRANÇAISESPAÑOL DEUTSCHScope of supply1x top triple clamp 1x bottom triple clamp 1x steering head bearing (preassembled) 1x steering head seal (preassembled) 1x steering stem (preassembled) 8x collar screw M8x401x collar screw M10x1.5 (preassembled) (tightening torque60 Nm)1x collar screw M8x25All work marked with this symbol requires specialist knowledge and technical understanding.In the interests of your own safety, have these jobs performed by an authorized KTM workshop.There, your motorcycle will be optimally cared for by specially trained experts using the auxiliary tool required.Preassembly of upper triple clamp- Remove screws from the original triple clamp.- Take off handlebar clamp (1 and the handlebar from the originaltriple clamp.- Remove screws (2 with lower handlebar mounts (3 and take offupper handlebar mounts (4 from the original triple clamp.- Remove rubber bushing (5 from the original triple clamp.- Mount rubber bushing (5 on the upper triple clamp (included).- Mount screws (2 with upper handlebar supports (4 and lowerhandlebar mounts (3 and tighten to 40 Nm (Loctite 243).- Position handlebars.- Mount screws with handlebar clamp (1 and tighten to 20 Nm.Preliminary work- Raise the motorcycle with a lift stand (see the Owner’s Manual).- Remove the front wheel (see the owner’s manual).- Remove the fork legs (see the owner’s manual).- Remove the start number plate (see the owner’s manual).- Remove the front fender (see the owner’s manual).- Remove the handlebar pad.- Remove the lower triple clamp (see the owner’s manual).