Husqvarna 2-20DT Global Operator's Manual

Also see for 2-20DT: Operator's manual

MaintenanceIntroductionWARNING: Before you domaintenance, you must read andunderstand the safety chapter.WARNING: Use personal protectiveequipment when you do servicing andmaintenance. Refer toPersonal protectiveequipment on page 8.WARNING: Before you do themaintenance, stop the motors anddisconnect the power plug from the powersource. Make sure that all drives stop.For all servicing and repair work on the product, specialtraining is necessary. We guarantee the availability ofprofessional repairs and servicing. If your dealer is nota service agent, speak to them for information about thenearest service agent.For more detailed information, refer towww.husqvarnaconstruction.com.Maintenance schedule* = General maintenance done by the operator. Theinstructions are not given in this operator's manual.X = The instructions are given in this operator's manual.O = The instructions are not given in this operator'smanual. Let an approved service agent do themaintenance.General product maintenance Each 3 h Daily 12 h afterserviceEach 3months YearlyMake sure that nuts and screwsare tight. * *Make sure that the power plugand extension cable are ingood condition and not dam-aged.*Do a check of the electricalcomponents, the cables andthe connections for wear anddamages.*Do a check of the RCD. *Examine the electric motor fordirt and damage. *Make sure that the dust extrac-tor hose is not damaged andthat there is no blockage.*Empty the dust extractor. *Do a check of the of the abra-sive separator, the separatortray and the feedspout.XClean the product. XDo a check of all safety devi-ces. XDo a check of the brush sealand magnetic seal for wear. X22 2037 - 001 - 07.02.2023