Husqvarna 135 Mark II Operator's Manual

Also see for 130 Mark II: Operator's manual Operator's manual Operator's manual Operator's manual

Contents

6. When the tree starts to fall, remove the product fromthe cut. Stop the motor, put the product down anduse the planned escape path. Be careful of limbsfalling from above and monitor your footing.To limb a tree1. Use larger limbs to hold the log off the ground.2. Remove small limbs in one cut.3. Cut branches that have tension from the bottom tothe top to prevent pinching the saw chain or theguide bar.To buck a logCAUTION: Do not let the saw chain touchthe ground.• If the log has support along its full length, cut fromthe top of the log (known as overbucking).• If the log has support on one end, cut 1/3 thediameter from below the log (known asunderbucking).• If the log has support on the two ends, cut 1/3 thediameter from the top. Complete the cut byunderbucking the lower 2/3 of the log to touch thefirst cut.• If you buck a log on a slope, always stay on theuphill side of the log. Cut through the log while youkeep complete control of the product. Then releasethe cutting pressure near the end of the cut whiletightly holding the rear handle and front handle.862 - 001 - 20.09.2018 15