Husqvarna 1200 Service Manual

Also see for 1100 CD: Operator's manual

Contents

24 Husqvarna service manual 104 72 30-262 The gap between the hook cover and driverThe hook cover is mounted on four fixed supports inthe arm. On those two on the right there are distancewashers.The distance between the hook cover and the drivershould be so big that the thread can pass freely on bothsides of the hook.RequirementsThe gap between the hook cover and the driver shouldbe such that when the hook is exchanged for the gauge411 16 49-01, the gauge should have no play but mustbe turnable.AdjustmentUndo the screws which hold the hook cover.Exchange the hook for the gauge and replacethe hook cover.Undo the screw (A) for the hook shaft and shiftthe shaft (B), without turning it, to the correct position.Tighten the screw.CommentThe shaft (B) is eccentrically mounted and if it isturned it will affect the play in the hook gear.Thereafter check:The gap between the hook and the needle (P.28).Setting of the stitch plate in relation to the needle, (P.29).SEWKNITWORLD