Husqvarna 120 Operator's Manual

Also see for 120: Operator's manual Operator's manual Operator's manual Workshop manual

Contents

your body that has come in contact with fuel. Usesoap and water.• If the product leaks fuel. Regularly do a check forleaks from the fuel tank, fuel cap and fuel lines.Safety instructions for maintenanceWARNING: Read the warning instructionsthat follow before you do maintenance onthe product.• Do only the maintenance and servicing given in thisoperator's manual. Let professional servicingpersonnel do all other servicing and repairs.• Regularly do the safety checks, maintenance andservice instructions given in this manual. Regularmaintenance increases the life of the product anddecreases the risk of accidents. Refer toMaintenance on page 18 for instructions.• If the safety checks in this operator's manual is notapproved after you do maintenance, speak to yourservicing dealer. We guarantee that there areprofessional repairs and servicing available for yourproduct.Safety instructions for the cuttingequipmentWARNING: Read the warning instructionsthat follow before you use the product.• Only use the guide bar/saw chain combinations andfiling equipment that we recommend. Refer toAccessories on page 27 for instructions.• Use protective gloves when you use or domaintenance on the saw chain. A saw chain thatdoes not move can also cause injuries.• Keep the cutting teeth correctly sharpened. Obey theinstructions and use the recommended file gauge. Asaw chain that is damaged or incorrectly sharpenedincreases the risk of accidents.(Fig. 28)• Keep the correct depth gauge setting. Obey theinstructions and use the recommended depth gaugesetting. Too large depth gauge setting increases therisk of kickback.(Fig. 29)• Make sure that the saw chain has the correcttension. If the saw chain is not tight against the guidebar, the saw chain can derail. An incorrect saw chaintension increases wear on the guide bar, saw chainand chain drive sprocket. Refer toTo adjust thetension of the saw chain on page 23.(Fig. 30)• Do maintenance on the cutting equipment regularlyand keep it correctly lubricated. If the saw chain isnot correctly lubricated, the risk of wear on the guidebar, saw chain and chain drive sprocket increases.(Fig. 31)AssemblyIntroductionWARNING: Read and understand the safetychapter before you assemble the product.To assemble the guide bar and sawchain1. Move the front hand guard rearward to disengagethe chain brake.2. Remove the bar nuts and the clutch cover. (Fig. 32)Note: If the clutch cover is not easy to remove,tighten the bar nut, engage the chain brake andrelease. A click is heard if it is released correctly.3. Assemble the guide bar onto the bar bolts. Move theguide bar to its most rear position.4. Install the saw chain correctly around the drivesprocket and put it in the groove on the guide bar.WARNING: Always use protectivegloves when you assemble the sawchain.5. Make sure that the edges of the cutters point forwardon the top edge of the guide bar. (Fig. 33)6. Align the hole in the guide bar with the chain adjusterpin and install the clutch cover.7. Tighten the bar nuts finger tight.8. Tighten the saw chain. Refer toTo adjust the tensionof the saw chain on page 23 for instructions.9. Tighten the bars nut.12 1063 - 002 - 06.03.2019