Husqvarna 115iPT4 Operator's Manual

Also see for 115iPT4: Operator's manual

General information about how to adjust thedepth gauge settingThe depth gauge setting (C) decreases when yousharpen the cutting tooth (A). To keep maximum cuttingperformance you must remove filing material from thedepth gauge (B) to receive the recommended depthgauge setting. SeeTechnical data on page 22 forinstructions about how to receive the correct depthgauge setting for your saw chain.ABCWARNING: The risk of kickback increases ifthe depth gauge setting is too large!To adjust the depth gauge settingBefore you adjust the depth gauge setting or sharpenthe cutters, refer toGeneral information about how tosharpen the cutters on page 17, for instructions. Werecommend you to adjust the depth gauge setting aftereach third operation that you sharpen the cutting teeth.We recommend that you use our depth gauge tool toreceive the correct depth gauge setting and bevel for thedepth gauge.1. Use a flat file and a depth gauge tool to adjust thedepth gauge setting. Only use Husqvarna depthgauge tool to get the correct depth gauge setting andbevel for the depth gauge.2. Put the depth gauge tool on the saw chain.Note: See the package of the depth gauge tool formore information about how to use the tool.3. Use the flat file to remove the part of the depthgauge that extends through the depth gauge tool.To adjust the tension of the saw chainWARNING: A saw chain with an incorrecttension can come loose from the guide barand cause serious injury or death.A saw chain becomes longer when you use it. It isimportant to adjust the tension of the saw chain regularlyto make sure that it is correct. Do a check of the tensionof the saw chain before you operate the product. Tightenthe saw chain as tightly as possible, but it must bepossible to pull the saw chain around freely by hand.Note: A new saw chain has a running-in period. Do acheck of the tension more frequently during this period.1. Turn the locking knob counterclockwise to unlock thechain tension adjuster.2. Turn the chain tension adjuster clockwise to tightenthe saw chain. Apply as much tension to the sawchain as possible. It must be tight against the guidebar.3. Make sure that you can pull the saw chain aroundfreely by hand and that it does not hang from theguide bar.4. Turn the locking knob clockwise to lock the chaintension adjuster.To lubricate cutting equipmentWARNING: Poor lubrication of cuttingequipment may cause the chain to snap,which could lead to serious, even fatalinjuries.WARNING: Do not use waste oil! Waste oilis dangerous for persons, the product andfor the environment.18 707 - 003 - 04.03.2019