Husqvarna 115 31 90-95 Operator's Manual

Contents

English14■ FLEXIBLE HOSE AND SWIVEL JOINT1. Connect the blower and swivel joint with flexible hose. Clamp both endsof the flexible hose securely with the hardware supplied with the unit.(1) Flexible hose (2) Swivel joint(3) Clamp (large) (4) Clamp (small)NOTEA light lubricant may be used to ease assembly of flexible hose toblower elbow.■ CONTROL HANDLE [130BT/350BT/370BTS/380BTS]1. Set up the handle holder to the swivel joint and tighten the knob on theholder.When setting up the handle holder, please make sure to match the handleholder to the convex on the swivel joint as shown in F2.2. Adjust the position and angle to achieve a comfortable workingposition, and tighten the control handle.(1) Cabling(2) Flexible hose■ CABLING [130BT/350BT/370BTS/380BTS][130BT]- Fasten the cabling at central position of the hose by the bandattached to the cabling.First, wrap the flexible hose with the band fixed to the cabling fromthe lower side.Then, pass the band through a hole of the band as shown in figure.Please note that there is a possibility of damaging the hose if theband is fastened too tightly.[350BT] [370BTS] [380BTS]- Use the clamp to fasten the cabling to the flexible hose.(1) Clamp■ RIGHT HANDLE [350BF/370BFS/380BFS]- Insert the handle holder to the swivel and tighten the knob on theholder.When setting up the holder, please make sure to match the holder to theconvex on the swivel joint as shown in F5.■ HANDLEBAR [OPTION] [130BT/350BT/370BTS/380BTS]1. Insert the holder, then assemble the handlebar (OPTION) and tighten itsecurely.(2)(1)(4)(3)F1(1)(2)F2F3[130BT](1)F4[350BT] [370BTS] [380BTS]F5F6Assembly