Husqvarna 115 09 83-95 Operator's Manual

Contents

English14 SWIVEL JOINT1. Connect the blower and swivel joint with flexible hose. Clamp bothends of the flexible hose securely with the hardware supplied with theunit.NOTEA light lubricant may be used to ease assembly of flexible hose toblower elbow. THROTTLE LEVER [130BT/150BT/170BT/180BT]1. Set up the throttle holder to the swivel and tighten the screw on theholder.When setting up the holder, please make sure to match the holder to theconvex on the swivel joint as shown in F2.2. Adjust the position and angle to achieve a comfortable workingposition, and tighten the throttle lever.(1) Cable(2) Hose THROTTLE CABLE [130BT/150BT/170BT/180BT][130BT]• Fasten the throttle cable at central position of the hose by the bandattached to the throttle cable.First, wrap the hose with the band fixed to the throttle cable from thelower side.Then, pass the band through a hole of the band as shown in figure.Please note that there is a possibility of damaging the hose if theband is fastened too tightly.[150BT] [170BT] [180BT]• Use the clamp to fasten the colgate tube containing the throttle cableand the power cable to the hose.(1) Clamp RIGHT HANDLE [150BF/170BF/180BF]• Insert the handle holder to the swivel and tighten the screw on theholder.When setting up the holder, please make sure to match the holder to theconvex on the swivel joint as shown in F5. HANDLEBAR [OPTION] [130BT/150BT/170BT/180BT]1. Insert the holder, then assemble the handlebar (OPTION) and tighten itsecurely.F1(1)(2)F2F3[130BT](1)F4[150BT] [170BT] [180BT]F5F6Assembly