English – 33To put the machine in order for storage follow theseinstructions:1. Carefully clean the machine, especially underthe cutting unit. Touch-up paint damage to avoidrust.2. Inspect the machine for worn or damaged partsand tighten loose screws and nuts.3. Change the oil, and take care of the waste oil.4. Empty the fuel tank. Start the engine and run ituntil the carburettor is emptied of fuel.5. Remove the plug and pour in a tablespoon ofengine oil in each cylinder. Pull round the engineto distribute the oil and screw the plug back on.6. Grease all grease nipples, joints and axles.7. Remove the battery. Clean it, charge it, andstore it is a cool place. Protect the battery fromlow temperatures (below freezing point).8. Store the machine is a clean and dry place andcover it over for extra protection.ServiceWhen ordering spare parts state the purchase year,model, type, and serial number.Always use genuine parts.Annual inspection or trimming by an authorisedservice workshop is a good way of getting the bestout of your machine the next season.Winter storageAt the end of the season the machine shouldimmediately be put in order for storage, also if it isgoing to stand idle for more than 30 days. Fuelwhich is left to stand for long periods (30 days ormore) can leave tacky deposits which can blockthe carburettor and interfere with the engine.Fuel stabiliser is an acceptable alternative to avoidtacky deposits during storage. If alkylate petrol(Aspen) is used stabiliser is not necessary sincethis fuel is stable. However, one should avoidchanging from standard to alkylate petrol sincesensitive rubber parts can harden. Add stabiliser tothe fuel in the tank or the storage container. Alwaysuse the mixing ratios indicated by the manufacturer.Run the engine for at least 10 minutes after addingthe stabiliser so that it will reach the carburettor. Donot empty the fuel tank and carburettor if stabiliserhas been added.STORAGEWARNING!Never place an engine with fuel inthe tank indoors or in poorlyventilated areas where petrol fumescan come into contact with nakedflames, sparks or pilot flames inboilers, hot water heaters, ordrying cabinets, etc. It is highlyinflammable and negligent usagecan cause severe person injuryand material damage. Drain offthe fuel in an approved containeroutdoors and well clear of nakedflames. Never use petrol for cleaningpurposes. Use degreasing agentsand hot water instead.!