Husqvarna 10527SBE Owner's Manual

Also see for 10527 SBE: Operator's manual

Contents

6ASSEMBLY / PRE-OPERATIONINSTALL TRACTION DRIVE CONTROL ROD(See Figs. 3 and 4)The traction drive control rod has the long loop on the endof the spring as shown.1. Slide rubber sleeve up rod and hook end of spring intopivot bracket with loop opening down as shown.2. With top end of rod positioned under left side of controlpanel, push rod down and insert top end of rod into holein drive control bracket. Secure with retainer spring.AUGERCONTROLRODCONTROLARMRUBBERSLEEVELOOPOPENINGUPFIG. 5INSTALL AUGER CONTROL ROD (See Figs. 5 and 6)The auger control rod has the short loop on the end of thespring as shown.1. Slide rubber sleeve up rod and hook end of spring intocontrol arm with loop opening up as shown.2. With top end of rod positioned under right side ofcontrol panel, push down on rod and insert end of rodinto hole in auger control bracket. Secure with retainerspring.TRACTION DRIVECONTROL RODPIVOTBRACKETRUBBERSLEEVELOOPOPENINGDOWNFIG. 3TRACTIONDRIVECON TROLRODDRIVECONTROLBRACKETRETAINERSPRINGTRACTION DRIVECON TROL LEVERFIG. 4AUGERCONTROLLEVERAUGER CONTROL RODAUGERCONTROLBRACKETRETAINERSPRINGFIG. 6