4. Push and hold the drive system lever (D) to movethe product rearward.5. Push and hold the overdrive button (A) to move atmaximum speed.6. Push and hold the forward button (B) to move theproduct forward.To move the product up and down arampWARNING: Be very careful when youmove the product up and down ramps. Theproduct is heavy and there is a risk of injuryif the product falls or moves too quickly.WARNING: For ramps with a steepslope, always use a winch. Do not walk orstay below or near the product.• To move the product down a ramp, operate theproduct forward slowly.• To move the product up a ramp, operate the productrearward slowly.• Do not turn the product to the left or to the right morethan 45° on a ramp.To lift the productWARNING: Make sure that the liftingequipment has the correct specification tolift the product safely. The type plate on theproduct shows the product weight.WARNING: Do not walk or stay belowor near a lifted product. Keep bystandersaway from the work area.WARNING: Do not lift a damagedproduct. Make sure that the lifting eye iscorrectly installed and not damaged.1. Attach the lifting equipment at the lifting eyes.2. Lift the product safely. Hold the handle until theproduct is lifted off the ground.To attach the product to atransportation vehicleUse the lifting eyes to attach the product to thetransportation vehicle.1. Attach the tie-down straps in the lifting eyes.2. Attach and tighten the tie-down straps to thetransportation vehicle.StorageCAUTION: Do not put the product instorage outdoors. Always keep the productindoors.• Keep the product in a dry and frost-free area.• Clean the product and do a complete servicingbefore you put the product in storage.• Keep the product in a locked area to prevent accessfor children or persons that are not approved.• Remove abrasive from the abrasive separator.Disposal of the product• Obey the local recycling requirements and applicableregulations.• When the product no longer is used, send it toa Husqvarna dealer or discard it at a recyclinglocation.26 2014 - 001 - 07.02.2023