INSTALLATION INSTRUCTIONS62-0255-09T775U Series 2000 ElectronicStand-Alone ControllerPRODUCT DESCRIPTIONThe T775 electronic stand-alone controllers are the nextgeneration of universal controls capable of remotesensing of temperature, humidity, pressure, etc. andproviding switched and proportional outputs to varioustypes of loads. A built-in time clock is standard.The T775U controller allows a wide range of sensors tobe configured. Humidity, pressure, temperature, or any0-5 Vdc, 0-10 Vdc, or 4-20 mA input is supported.A Reset function is available where the Sensor Btemperature (e.g. outside temperature) is used to providereset control for Sensor A (e.g. humidity). For example,as the outside temperature gets colder, the setpoint canautomatically be adjusted to prevent condensation.IMPORTANTThe T775U is an operating control, not a limit orsafety control. If used in applications requiringsafety or limit controls, a separate safety or limitcontrol device is required.Table 1. T775U Controller Configurations.ControllerModelaa The T775U includes a digital input for use with the disable or setback option.Description ReplacesOutputResetSPDTRelayOutputsAnalog(Mod)Outputsbb The modulating (analog) outputs may be 4-20 mA, 0-10 Vdc, 2-10 Vdc, or Series 90 selectable.SensorInputsNbr ofSensorsIncluded EnclosureT775U2006Universal:Humidity,Pressure,Temperature,etc.H775A1006H775A1022H775A1048H775A1063H775B1005H775C1004cH775D1003cH775E1002cc For the H775C1004, H775D1003, and H775E1002 model replacement, the T775U only partially replaces the functionof these devices. Check application for suitability.Yes 2 2 2 dd For the sensor inputs, Sensor A can be 0-10Vdc, 4-20mA, or a standard temperature input. Sensor B is a standardtemperature sensor input only. Sensor B is used only for reset on the T775U2006.None NEMA 1T775U2016 N/A Yes 2 2 2 ee The T775U2016 can control Sensor A (universal) and Sensor B (temperature) independently, like other standardT775 controllers.None NEMA 1