Honeywell Silent Knight 6820EVS Basic Operating Instructions Manual

Also see for Silent Knight 6820EVS: Manual Installation and optimization guide Installation and operation guide Manual

Honeywell Silent Knight 6820EVS Basic Operating Instructions Manual Manual pdf 1 page image

Cut Along the Dotted LineP/N: LS10161-001SK-E Rev AECN: 16-02186820EVS Basic Operating InstructionsThese instructions must be framed and displayed next to the 6820EVS panel in accordance withNFPA 72 fire code for Local Protected Fire Alarm SystemsFS= Fire System EVS = Emergency Voice SystemOperation Task to PerformSilence Alarms andTroubles Press SILENCE then enter a code if prompted. Silence LED will light.Reset Alarms1. Press RESET.2. Press 1 to Reset Fire System.3. Press 2 to Reset Emergency System.Note: To reset EVS at an LOC, the user must gain EVS Control. (See Figure 1).View all active alarms,troubles, andsupervisories signalsThe highest priority event will display first. Press the Down arrow to view location and type of alarm ortrouble.View a Point’s Status1. Press ENTER to access Main Menu.2. Press 2 to select Point Functions.3. Then press 2 to select Point Status.4. Select the module the device is located on by using the Up or Down button. Then press ENTER.5. Enter the point number.Conduct a Fire Drill1. Press ENTER to access Main Menu.2. Then Press 1 to select System Tests.3. Press 1 to select Fire Drill.4. Press ENTER to start the fire drill.5. Press ENTER to end the fire drill.Set Time and Date1. Press ENTER to access Main Menu.2. Then press 4 to select Set Time & Date. Enter a code if prompted3. Make changes in the fields on the screen as necessary.4. Press ENTER if you wish to keep the changes.5. Press ENTER to set the entered time and date.Enable / Disable a Point1. Rotate the key or enter a code to access to access Main Menu.2. Press 2 to select Point Functions.3. Press 1 for Disable / Enable Pt4. Press 7 for Disable / Enable Pt.5. Use the Up or Down button to move through the list. Then press ENTER to select the module wherethe point you want to disable/enable is located6. Enter the point or circuit number that you want to disable/enable.7. Press the right arrow key to toggle between NORMAL (enable) or DISABLE.To Gain / Request EVSControl1. Press the Button and follow the on-screen Instructions.Note: When EVS Control LED is blinking, another LOC has EVS Control. EVS Control LED is on steadywhen the LOC has EVS Control.For Service Call:

/ 5

Related manuals for Honeywell Silent Knight 6820EVS