Honeywell H-S81-HS Manual

Also see for H-S81-HS: Operation manual

Contents

Honeywell H-S81-HS Manual Manual pdf 49 page image

49 Safety Bus Manual — P/N LS10177-000HI-E:B 02/21/2019System Components SB-PRG Programmer• The reset command has not been executed by the panel (Reset) Ch-11 EV-Primary/TOA/TO OutputThis output can be configured during programming as EV-Primary, TOA or TO.If configured as EV-Primary, activation occurs as with channel 9.If configured as TOA or as TO, these outputs are managed as with Type-1 embedded logic. Ch-12 EV-Secondary/TOA/TO OutputThis output can be configured during programming as EV-Secondary, TOA or TO.If configured as EV-Secondary, activation occurs as with channel 10.If configured as TOA or as TO, these outputs are managed as with Type-1 embedded logic.3.8 SB-PRG ProgrammerThis is a programmer that can be used to set the CAN BUS address of Safety Bus modules.3.8.1 Technical Specifications• Visualization on an alphanumeric display• Verification/Programming of Safety Bus module addresses• Quick connector for connection to the modules• Membrane buttons• Battery low indicator• 9 VDC power supply (with provided alkaline battery)• Current consumption in stand by: 5mA• Operating temperature: -5 - 50 °C (23 - 122°F)• Storage temperature: -30 - 80 °C (-22 - 176°F)• Max humidity: 95% non condensingNOTE: The output that controls secondary discharge is activated immediately following theactivation of the secondary sequence manual operation input without a delay.