Healthrider 831.287940 User Manual

Also see for AEROBIC RIDER 2: User manual User manual User manual User manual

Contents

Healthrider 831.287940 User Manual Manual pdf 4 page image

4ASSEMBLYBefore beginning assembly, carefully read thefollowing information and instructions:• Place all parts in a cleared area and remove thepacking materials; do not dispose of the packingmaterials until assembly is completed.• Read each assembly step before you begin.• For help identifying the small parts used inassembly, use the part identification chartbelow. The number in parenthesis below eachpart refers to the key number of the part. Thesecond number refers to the quantity needed forassembly. Note: Some small parts may havebeen pre-attached for shipping purposes. If apart is not in the parts bag, check to see if ithas been pre-attached.• Tighten all parts as you assemble them, unlessinstructed to do otherwise.• During assembly, make sure that all parts are ori-ented as shown in the drawings.THE FOLLOWING TOOLS (NOT INCLUDED)ARE REQUIRED FOR ASSEMBLY:• Two (2) adjustable wrenches• One (1) phillips screwdriver• You will also need some lubricant, such aspetroleum jelly or grease.Assembly will be more convenient if you have thefollowing tools: A socket set, a set of open-end orclosed-end wrenches, or a set of ratchet wrenches.M8 Acorn Nut (56)–41/4” Flat Washer (57)–14 M9 Rubber Sheild Washer (58)–4M8 x 157mm Axle (59)–23/8” Pivot Bushing (41)–1M6 Square Nut (4)–2 M6 Hex Nut (2)–6 3/8” Nylon Lock Nut (31)–13/8” Flat Washer (55)–4Weight Tube Screw (54)–1M6 x 35mm Bolt (3)–2 M6 x 40mm Bolt (60)–6 3/8” x 1 3/8” Shoulder Bolt (61)–1