Menu
Health Zenith 5910 User Manual
                    | |
4 598-1378-00180°70 ft.(21 m)8 ft.(2.4 m)Maximum Range MaximumCoverage AngleNOTE: If fixture is mounted higher than 8 ft. (2.4 m), aim-ing the sensor down will reduce coverage distance.The detector is less sensitive to motion directly towards it.3. Loosen the clamp screw in thesensor ball joint and gentlyrotate the sensor.4. Walk through the coveragearea noting where you arewhen the lights turn on (also,the LED will flash several timeswhen motion is detected). Movethe sensor head up, down, orsideways to change the cover-age area. Keep the sensor atleast 1" (25 mm) away fromthe bulbs.5. Adjust the RANGE as needed.RANGE set too high mayincrease false triggering.6. Secure the sensor head bytightening the clamp screw.Do not overtighten the screw.7. Set the amount of ON-TIME you want the lights to stayon after motion is detected (1, 5, or 10 minutes).Bottom of SensorAvoid aiming the control at:• Objects that change temperature rapidly, such asheating vents and air conditioners. These heatsources could cause false triggering.• Areas where pets or traffic may trigger the control.• Nearby large, light-colored objects reflecting lightmay trigger the shut-off feature. Do not point otherlights at the sensor.ClampScrewBallJointAim SensorDown for ShortCoverageAim SensorHigher for LongCoverageLeast Sensitive Most SensitiveWARNING: Risk of fire. Do not aim the lampheads at a combustible surface within 3 ft. (1 m).TEST AND ADJUSTMENT1. Turn on the circuit breaker and light switch.NOTE: Sensor has a 1 1/2 minute warm up periodbefore it will detect motion. When first turnedon, wait 1 1/2 minutes.2. Turn the RANGE control to the medium position(halfway between MIN and MAX) and the ON-TIMEcontrol to the TEST position.Motion MotionSensorPhotocellRANGE10 5 1 TESTON-TIMEMIN MAX |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved