Menu
Heal-Tech SpeedoHealer v3.0 User Manual
    |
SH_UsersGuide_en.pdf - 1 -http://www.speedohealer.comSpeedoHealer v3.0- Electronic Speedo and Odometer Calibrator with Top Speed Memory -User’s Guide1. ForewordCongratulations on your purchase of a SpeedoHealer calibrator unit.At Heal-Tech Ltd. we are committed to producing the best calibrator devices available and we wouldlike to thank you for choosing our product.The installation kits are packed and sold separately. Please find the latest Application list on ourwebsite (or ask an authorized SH dealer) and purchase the Harness Kit suitable for your bike.After the installation, it is best to use our on-line calculator to calculate the required calibration valueand to generate the step-by-step programming instructions. You can also download the calculator foroff-line use. Reading this Guide is only necessary if you don’t have Internet access to our website.2. Setting and Using your SH2.1 Assigned functions to SH switchesSwitch no. inON position Selected Function Possible values set by the button1 Test mode on/off Change the emitted frequency(x 2, in 10 steps)2 Set the Conversion mode value0: no conversion1: mile → km2: km → mile3 Set the Sign of Calibration value 0: Negative1: Positive4 No. of Tens in Calibration value 0..95 No. of Ones in Calibration value 0..96 No. of Tenths in Calibration value 0..9All Reset Press to confirm2.2 Programming the unit1. At first, you have to determine the Calibration and Conversion mode values needed foryour application. If you can’t access the on-line calculator, refer to chapter 3.Normally the Conversion mode value is zero, unless you have an import bike/speedo withdifferent units of measure than in the country you live in.2. It is recommended to start the programming sequence by a Reset command.Set all switches to ON position and turn the ignition On. The LED blinks once.[After a few seconds the product identification code is transmitted via the LED - ignore]Press the button, the LED lights up. Release the button.If you wish to set the unit into Transparent mode, then flip all switches down while theignition is still on. The LED flashes rapidly for 3 seconds to confirm that all parametershave been cleared (factory default). Otherwise, continue with the next step. |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved