Hasselblad 503CW User Manual

Also see for CFV: User manual Brochure User manual addendum User manual

Contents

Hasselblad 503CW User Manual Manual pdf 72 page image

72501CM..29980429COPYRIGHT © 1998 ANDERS ENGSTRÖMANDERS ENGSTRÖM, ILLUSTRATÖRÖstra vägen 46430 91 HÖNÖtel/fax 031-96 84 64anders@aeillustr.se501CM..26980429COPYRIGHT © 1998 ANDERS ENGSTR÷ MANDERS ENGSTR÷ M, ILLUSTRAT÷ R÷ stra v‰gen 46430 91 H÷ N÷tel/fax 031-96 84 64anders@aeillustr.se501CM..27980429COPYRIGHT © 1998 ANDERS ENGSTR÷ MANDERS ENGSTR÷ M, ILLUSTRAT÷ R÷ stra v‰gen 46430 91 H÷ N÷tel/fax 031-96 84 64anders@aeillustr.se501CM..26980429COPYRIGHT © 1998 ANDERS ENGSTR÷ MANDERS ENGSTR÷ M, ILLUSTRAT÷ R÷ stra v‰gen 46430 91 H÷ N÷tel/fax 031-96 84 64anders@aeillustr.se501CM..25980429COPYRIGHT © 1998 ANDERS ENGSTR÷ MANDERS ENGSTR÷ M, ILLUSTRAT÷ R÷ stra v‰gen 46430 91 H÷ N÷tel/fax 031-96 84 64anders@aeillustr.se501CM..23980429COPYRIGHT © 1998 ANDERS ENGSTR÷ MANDERS ENGSTR÷ M, ILLUSTRAT÷ R÷ stra v‰gen 46430 91 H÷ N÷tel/fax 031-96 84 64anders@aeillustr.se503CW..19C.blÂ960828COPYRIGHT © 1996 ANDERS ENGSTR÷ MANDERS ENGSTR÷ M, ILLUSTRAT÷ R÷ stra v‰gen 46430 91 H÷ N÷tel/fax 031-96 84 64anders@aeillustr.se501CM..22980429COPYRIGHT © 1998 ANDERS ENGSTR÷ MANDERS ENGSTR÷ M, ILLUSTRAT÷ R÷ stra v‰gen 46430 91 H÷ N÷tel/fax 031-96 84 64anders@aeillustr.se501CM..21980429COPYRIGHT © 1998 ANDERS ENGSTR÷ MANDERS ENGSTR÷ M, ILLUSTRAT÷ R÷ stra v‰gen 46430 91 H÷ N÷tel/fax 031-96 84 64anders@aeillustr.se501CM..19980505COPYRIGHT © 1998 ANDERS ENGSTRÚMANDERS ENGSTRÚM, ILLUSTRATÚRÚstra v� gen 46430 91 HÚNÚtel/fax 031-96 84 64anders@aeillustr.se501CM..20980429COPYRIGHT © 1998 ANDERS ENGSTRò MANDERS ENGSTRò M, ILLUSTRATò Rò stra v� gen 46430 91 Hò Nòtel/fax 031-96 84 64anders@aeillustr.se5 67 891011Step-by-step film loading 1–8Follow the procedure below in the correct order.1. Fold out the film holder key.2. Turn the key counter-clockwise and withdraw the film holder(magazine insert).3. Place an empty take-up spool under the grooved knob of thespool clamp bar. Insert a roll of film under the other end ofthe bar, turned the same way as in the illustration. Be sure toremove all of the paper band surrounding a new roll of film.4. Turn the film holder key clockwise to open the film clamp.Pull 8 -10 cm (3 - 4 in.) of paper backing off the film roll andslide the edge under the clamp.5. Insert the tongue of the backing paper into the slot in thetake-up spool.6. Turn the grooved knob clockwise until the arrow on thepaper backing is aligned opposite the triangular index (oroblong index with Ilford black & white film, see ‘Magazinetips’) on the spool clamp bar, but no further.7. Turn the film holder key counter-clockwise and insert thefilm holder into the magazine. Ensure that it is correctlypositioned. Turn the film holder key clockwise to lock the filmholder in the magazine and then fold the key back into place.8. Fold out the film crank and rotate it clockwise about ten turnsuntil it stops. Then turn it counter-clockwise and fold it in. Thefigure (1) will now be displayed in the automatic frame-coun-ter window indicating that the magazine is loaded and readyfor use.Magazine load status 9In the centre of the film holder key there is a crescent-shapedindicator window that shows white when the magazine is freshlyloaded. It gradually changes to red as the film is wound through.An all red indicator shows that either the film is used up or that themagazine is empty.Removing film from the magazine 10When the last frame has been exposed and wound on, the magazineblocks the camera for further release.Wind off the film by folding out the film winding crank, and rotateit clockwise until you can feel the film leaving the supply spool.You can now withdraw the film holder from the magazine andremove the exposed film.The frame counter is automatically reset when the film holder iswithdrawn from the magazine.Film tab holder 11The end tab of the film pack can be inserted in the holder on theback of the magazine as a reminder of the kind of film that has beenloaded into the magazine.13 42