Menu
Harpo BraillePen12 User Manual
Also see for BraillePen12: User guide
                                         | |
Contents
| 
BraillePen12 sound signalsBraillePen12 communicates its status using high-pitched beeps. When you first turn yourBraillePen12 on, it give several beeps.First you hear a single short beep to let you know that the BraillePen12 is on.Then you hear a set of beeps to tell you the battery status.The third set of beeps tells you that the BraillePen12's Bluetooth interface is active and canmake a connection with another device.The sound for "BraillePen12 on" and the sound for "Bluetooth active" don't change; thebattery sounds will change depending on how much charge there is. Here is the full list ofbattery status beeps:One long beep, pause, three short beeps means that the unit is not connected to the powerand the battery is fully charged.One long beep, pause, two short beeps means that the unit is not connected to the power,and the battery is charged to half its capacity.One long beep, pause, one long beep means that the unit is not connected to the power, andthat the battery is drained and needs to be recharged immediately.Two mid-length beeps means that the unit is connected to power and the battery is charging,but doesn't report on the state of the battery.Two mid-length beeps, pause, three short beeps means that the unit is on charge, and thebattery is already fully charged.Connecting the BraillePen12Before switching your BraillePen12 on, make sure you first turn on the device you want toconnect to. When your device is on, then turn the BraillePen12 on by pressing space anddots 1 and 3 together.Sometimes the connection can take up to 20 seconds to complete, after both devices havebeen switched on. Listen for the triple-beep that tells you BraillePen12's Bluetooth interface isactive, and allow up to 20 seconds from there.If you are connecting to a PC or netbook for the first time, you will need to discover theBraillePen12 as a Bluetooth device. Once discovered, the connection will be madeautomatically every time after that.If your BraillePen12's battery is getting a little low, you might notice that it's more difficult toconnect to other devices, or to stay connected. Recharge the battery, and then consult theCare and Resources section of this manual to find out how to reset your BraillePen12.Bluetooth Adapter TypesBraillePen12 is compatible with four adaptor types: WIDCOMM, Toshiba, Microsoft andBlueSoleil. The instructions here apply to those Bluetooth adapters using the MicrosoftBluetooth drivers. If your Bluetooth doesn't work as described, check in the Care andResources section for connection information for other Bluetooth discovery methods.Under Windows XPFirst turn on your BraillePen12, and wait for the triple-beep. Next go to the Control Panel andchoose Bluetooth. Select Add a Device and wait while Windows discovers the device.3 |
Related manuals for Harpo BraillePen12
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved