Hardinge 16C Instructions For Use Manual

Hardinge 16C Instructions For Use Manual Manual pdf 1 page image

16C Low-Pressure Dead-Length Collet Blocks Instructions B-145Hardinge Inc. One Hardinge Drive, Elmira, New York U.S.A. 4902-507 800.843.880 (Canada 800.468.5946) www.hardingetooling.comPart No. B -0009500-0456C Collet BlockLow-Pressure, Pneumatic or Hydraulic, Double Acting, Dead-LengthPart No. 7799-00-00-000096Specifications• Maximum unit operating pressure – 250 psi air, 2000 psi hydraulic(17 bar air, 137 bar hydraulic)• Draw tube force – 5.8 x line pressure• Collet capacity – 16C {1/64" to 15/8" (.39 to 41.27mm) round}• Thru-hole in base• Four 1/4-20 mounting holes in bottom of base• Two 3/8" (9.52mm) dowel holes in bottom of base• Two 1/4"-18NPT ports• 2-position, 4-way control valve recommended for hydraulic operation,2-position, 3-way control valve recommended for pneumatic operation (not included)Safety• Do not over tighten the mounting hardware or the plumbing fittings.• When installing a collet in the closer, do not over tighten the collet.• Do not exceed maximum operating pressure of 250psi air or 207 psi hydraulic (7 bar air, 83 bar hydraulic).• Make sure that the collet retains your material when the closer is closed.ApplicationThis 16C collet block is a stationary unit with a double-acting cylinder. It is effective on machine and assembly operationsthat require reliable clamping and unclamping. Use the collet block as a single unit or mount multiple closers on rotarytables, pallets, fixtures or tombstones for increased productivity.Installation1. Mount the collet block to a rigid flat surface.2. Plumb your first supply line using 5000 psi (344 bar) rated steel tubing to the CLAMP 1/4 NPTF port of thecollet block and the normally OPEN 1/4 NPTF port of your control valve.3. Plumb your second supply line using 5000 psi (344 bar) rated steel tubing to the UNCLAMP 1/4 NPTF port ofthe collet block and the normally CLOSED 1/4 NPTF port of your control valve.4. Plumb your control supply to the 1/4 NPTF pressure port of the valve.5. This configuration maintains a closed collet until the valve is actuated.Operation1. Remove the supply from the valve.2. Loosen the collet locking screw.3. Insert the collet in the top of the collet block.

/ 4

Related manuals for Hardinge 16C

Hardinge 3C Instructions For Use Manual

Hardinge HQC Installation Instructions Manual

Hardinge 16C Mounting Instructions

This manual is suitable for:

16C

Hardinge 16C Instructions For Use Manual

Product

Learn More

Legal