Menu
Harbor Freight Tools Storm Cat 60338 Owner's Manual & Safety Instructions
                    | |
Page 10 For technical questions, please call 1-888-866-5797. ITEM 60338SaFeTy SeTup OperaTiOn MainTenanCeBreak-in period:a. Breaking-in the engine will help to ensure proper equipment and engine operation.b. The break-in period will last about 25 hours of use. DO NOT exceed75% of the Generator’s rated capacity during this period.• Change the engine fuel/oil mixture after this period.Under normal operating conditions subsequent maintenance followsthe schedule explained in the MAINTENANCE section.Connecting Loads to the GeneratorLoad and Circuit Breaker:1. The total combined load through the outleton the Generator must not exceed therated maximum power of the unit.2. Reduce the load if the AC Circuit Breaker turns off.Once the load is reduced, press the Circuit BreakerButton to reset the Generator and continue operation.Calculate power Draw:Power draw can be calculated by multiplying voltsand amps. The resulting number is wattage.• Never exceed the rated maximum wattage forthe Generator or any outlet amperage rating.• Refer to appliance/tool owner’s manuals todetermine the wattage of electrical load devices.• Long power cords and extension cords drawadditional power. Keep cord length at a minimum.Wattage estimatesWattages listed below are estimates for thattype of equipment only. Check nameplate wattageson all loads before connecting to Generator.This unit Can power anyOne of the Following items:runningWattspeakWattsCamping 50-700Tailgating 50-700Radio 50-200Table/Box Fan 20015 Amp Battery Charger 380Outdoor Power Equipment 500Mini Refrigerator 400 700Ten 60 Watt Light Bulbs 6003. Allow the Engine to run at no load for five minutesafter each start-up to allow the Engine to stabilize.Figure B: plug Load in4. Plug the power cord of the 120 volt appliance/tool into the 120 volt AC Outlet on the Generator.note: Do not allow the generator to completely runout of fuel with devices attached. a generator’soutput may sharply spike as it runs out of fuel,causing damage to attached devices.Figure C: unplug Load3. When finished using the appliance/tool, turn it offand unplug it from the AC Outlet on the Generator.Stopping the engine1. To stop the engine in an emergency,turn the Engine Switch off.2. Under normal conditions, use the following procedure:a. Remove all electrical load devicesfrom the Generator.b. Turn the Engine Switch off.c. Close the Fuel Valve.OFFOFFONNOTICESee Long-Term Storage on page 13for complete storage instructions. |
Related manuals for Harbor Freight Tools Storm Cat 60338
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved